Connected. Use the WiFi name and the WiFi password you set to connect your wireless devices to
the router. Now, you can access the internet through your wireless and wired devices.
LED indicators
LED Indicator: Status: Description
SYS:
Solid on: *The router is starting. **The system is faulty after startup.
Slow blinking: The system is working properly.
Fast blinking twice (AC10U only): A portable USB device is connected to the USB port.
Fast blinking (AC10U only): Data is transmitting over the USB port.
WAN:
Solid on: The WAN port is connected properly.
Fast blinking: Data is transmitting over the WAN port.
Off: The WAN port is disconnected or connected improperly.
LAN:
Solid on: Port 1, 2 or 3 is connected properly.
Blinking twice: A new device is connected to port 1, 2 or 3.
Off: None of ports 1, 2 and 3 is connected or connected properly.
WiFi:
Solid on: At least the 2.4 GHz or 5 GHz WiFi network is enabled.
Fast blinking: Data is transmitting wirelessly.
Slow Blinking: The router is performing WPS negotiation.
Off: The wireless function is disabled.
Port / Button: Description
WIFI: Used to enable/disable the WiFi of the router.
RST/WPS: Used to start the WPS negotiation process of the router, or to reset the router.
* WPS: Press the button of the router, and enable the WPS function of another device within 2 minutes
to establish a WPS connection.
** Reset: Hold the button down for about 8 seconds. Reset succeeds when all LED indicators blink
To Next Page
Loading...
Need help?
General
