It is suggested that you choose WPA-personal for “Security Mode” and AES for “WPA Algorithms.”
Input 8 ~ 63 numbers, letters, and symbols for pass phrase. Click “Next” to save the configuration.
More details please refer to the following chapter.
Click “Apply” to save the configurations and the router will be rebooted automatically.
Note: Make sure the device have the same Channel, Security mode and Extend channel as
the access point.
13. Go back to Network connections and reset your computer IP address to the previous IP or
Obtain IP address automatically.
14. Disconnect from PC and connect to Receiver, set fixed IP address or DHCP, both will work.
That’s it, you now be setup and running, that’s how easy it is!
This guide has been supplied by www.world-of-satellite.com
To Previous Page
Loading...
