Need help?Do you have a question about the Tenda AP Series and is the answer not in the manual?
General| Model | AP Series |
|---|---|
| Category | Wireless Access Point |
| Frequency Range | 2.4GHz/5GHz |
| Wireless Standards | IEEE 802.11a/b/g/n/ac |
| Wireless Speed | Up to 1200Mbps |
| Operating Mode | Repeater |
| Security | WPA/WPA2-PSK |
| Antenna | External antennas |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
| Operating Humidity | 10% to 90% non-condensing |
| Storage Humidity | 5% to 95% non-condensing |
Explains the status lights on the AP and their meanings.
Describes two methods for attaching the mounting bracket using anchors or nuts.
Connects AP to included PoE injector and then to a power source.
Connects AP to a PoE switch for power and data transmission.
Manages APs in batches via a Tenda hardware controller.
Guides on logging into the AP's web interface and setting SSID/Key.
Instructions to set the AP's IP address to match the uplink network segment.
Illustrates connecting APs and a computer for wireless bridging.
Details selecting the wireless network and entering the key for bridging.
Addresses common problems like failing to log into the web UI or controller detection.
Troubleshoots wireless bridge failures and explains how to restore factory settings.
To Next Page
