Tenda AP Series User Manual

Port/button
DescriptionPort/Button
RESET
LAN/PoE
Cable Fix Notch
Reset button, used to restore the AP to factory
settings.
When AP is not busy, hold down this button
with a needle-like object for about 8 seconds
and release it when the LED indicator turns off.
When the LED indicator is blinking white, AP is
reset successfully.
Gigabit Ethernet port, which supports both PoE
power input and data transmission. It is gener-
ally used to connect to the upstream switch.
You can power the AP by:
- the included PoE injector.
- other PoE power supply devices, complying
with IEEE 802.3at standard.
It is used to fix Ethernet cables to the AP.
Cable Fix Notch
- 3 -
RESET
LAN/PoE

Tenda AP Series Specifications

General

Model	AP Series
Category	Wireless Access Point
Frequency Range	2.4GHz/5GHz
Wireless Standards	IEEE 802.11a/b/g/n/ac
Wireless Speed	Up to 1200Mbps
Operating Mode	Repeater
Security	WPA/WPA2-PSK
Antenna	External antennas
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing