Tenda Wireless Network Adapter User Guide
wireless signal and create a wireless network, while allowing
other wireless clients to access this network.
As shown in the diagram below: The PC in the left has already
accessed to the Internet by using a wired network adapter,
meanwhile, you install a Tenda wireless adapter (take a USB
wireless adapter as an example) and its UI on this computer,
and set the adapter to AP mode.
By using the wireless adapters to scan the AP’S SSID to connect,
the computers in the right can also access to the Internet after
successfully connected
In this mode, the client utility differs from that in station mode,
and the main interface is as shown below.
-42-
To Next Page
Loading...