EasyManua.ls Logo

Tenma 72-8732 - Important Safety Information; Whats Included; Features

Tenma 72-8732
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Please read these instructions carefully before use and retain for future reference.
Please operate according to this manual, otherwise the protection provided by the
device will be impaired or fail.
Do not point laser directly in your eyes or indirectly off reective surfaces.
Check the condition before using. If you nd any cracking, breakage, damage or
abnormality, or you consider the device broken, stop using the device immediately
Do not use the Thermometer if it operates abnormally. Protection may be impaired.
When in doubt, have the Thermometer serviced.
Do not operate the Thermometer around explosive gas, vapour, or dust.
To avoid a burn hazard, remember that highly reective objects will often result in
lower than actual temperature measurements.
To avoid damaging the thermometer or the equipment under test protect them from
the following:
EMF (electro-magnetic elds) from arc welders, induction heaters, etc.
Static electricity.
Thermal shock (caused by large or abrupt ambient temperature changes –
allow 30 minutes for the Thermometer to stabilize before use).
Do not leave the Thermometer on or near objects of high temperature.
Replace the batteries as soon as the low battery indicator appears on the display.
Remove dead batteries from the Thermometer or if it is not going to be used for a
long time.
Never mix old and new batteries together, or different types of batteries.
Never dispose of batteries in a re, or attempt to recharge ordinary batteries.
Before replacing the battery, turn off the Thermometer and disconnect all the test
probes.
To prolong battery life turn off the Thermometer after use.
IMPORTANT SAFETY INFORMATION
WHAT’S INCLUDED
FEATURES
Infrared Thermometer with laser sighting.
9V 6F22 Alkaline Battery (included)
Instruction manual
Single-spot laser sighting.
White backlight.
Synchronous display of the measured maximum and minimum value.
Celsius and Fahrenheit temperature measurement.
Dynamic battery capacity monitoring.
Low voltage indication.
Display screen.
Adjustable emissivity.
Alarm sounder for upper and lower limit.