2
Please read these instructions carefully before use and retain for future
reference.
This instrument is designed & manufactured in compliance with: G84793, lEC61010-1,
CAT III 1000V, & CAT IV 600V Pollution Degree 2 and Double Insulation standards.
• Please operate according to this manual, otherwise the protection provided by the
device will be impaired or fail.
• Check the test leads, probe and case insulation condition before using. If you nd
any breakage, damage or abnormality, or you consider the device is broken, stop
using the device immediately.
• When using the test probes, keep your ngers behind the nger protection rings.
• Ensure all inputs are less than the range selected otherwise it may cause electrical
shock or meter damage.
• If the value to be measured is unknown, use the maximum measurement position
and descend in values until a correct reading is displayed.
• Take caution when voltages are above 60V DC and 30V AC rms.
• Disconnect circuit power and discharge all high-voltage capacitors before testing
resistance, diode and current.
• Do not use the meter with the back cover removed.
• Do not adjust the range selector during measurement.
• Replace the batteries as soon as the low battery indicator appears on the display.
• Remove dead batteries from the meter or if it is not going to be used for a long
time.
• Never mix old and new batteries together, or different types of batteries.
• Never dispose of batteries in a re, or attempt to recharge ordinary batteries.
• Before replacing the battery, turn off the meter and disconnect all the test probes.
• To prolong battery life turn off the meter after use..
ELECTRICAL SYMBOLS GUIDE
WHAT’S INCLUDED
• Digital Multimeter.
• 1 pair of test leads.
• Temperature probe.
• Alligator clip.
• Test clip.
• USB interface cable.
• CD Rom PC software.
• Storage bag.
• Power adaptor.
• 9V battery.
IMPORTANT SAFETY INFORMATION
Low battery Grounding Warning
Double insulated AC DC Measurement
Fuse Diode AC/DC Measurement
To Next Page
