Tennsmith Inc. / 6926 Smithville Hwy. / McMinnville, TN 37110 / 931-934-2211 / Fax 931-934-2220
www.tennsmith.com
SAFETY INSTRUCTIONS
1. Know the safety and operating instructions contained in this manual prior to operation of this shear.
Become familiar with and understand the hazards and limitations of this shear. Always practice
safety.
2. Wear approved eye safety protection, such as safety glasses or goggles, etc., when operating the
shear to protect your eyes.
3. Protective type footwear should be worn, and jewelry such as rings, watches, necklaces, etc., should
be removed prior to operation of this shear.
4. Do not remove the front hold-down guard (Index # 3). This is a protective device. If the hold-
down is inoperable, immediately stop using the machine, and contact Tennsmith or your
authorized distributor for a replacement part.
5. Keep the hold-down (Index #3) at the minimum gap required to feed the material into the
shear. The gap should never be higher than 3/16” from the table. If you have questions
regarding the Hold-down, please consult the factory.
6. Always keep hands clear of the blade.
7. Do not misuse the shear by using it for other than its intended purpose.
8. Never exceed the rated capacity of this machine.
9. Keep the work area clear and clean to avoid tripping or slipping.
10. Any malfunction or abnormality pertaining to this machine should be reported to the maintenance
supervisor immediately.
ShopRPMachinne
To Next Page
Loading...
