6
This is the default operating mode. LATITUDE will accept controller (wireless) and/or thumbwheel
commands, and forward them to the motor(s) and camera. Standard mode also enables LATITUDE’s
Wi-Fi access point, adding full Wi-Fi/FoolControl capability to DSMC and DSMC2 cameras.
LATITUDE M and MB receivers have several dierent operating modes. To change the receiver’s
operating mode, press the recessed operating mode button (K).
Standard Mode - GREEN LIGHT
STANDALONE OPERATING MODES
In Flight Mode, the Latitude will disable its wireless module. This is useful for saving battery power if
the system is being controlled via wired mode. No wireless data will be transmitted.
Flight Mode - CYAN LIGHT
In Transmitter Mode, the LATITUDE will route the input signals (i.e. plugged into IN-1, IN-2) over the
RF link to the LATITUDE on camera. This enables many unique congurations, including using two
thumbwheels (plus LATITUDE) on a director’s monitor to control Focus/Iris and run/stop.
Transmitter Mode - PURPLE LIGHT
To Next Page
Loading...