Note:
If any of the safety signs shown in this section are missing or damaged, contact
your dealer to obtain a replacement.
Key (continued)
11. Belt/fan entanglement hazard
12. Skin (oil) injection hazard
13. Crush hazard (lift arm brace)
14. Crush Hazard (Lift arms)
15. Fall hazard / rollover Hazard / read operator’s manual
16. Crush / fall hazards
17. Crush (run over) hazard
18. Clean undercarriages notice
19. Tie down location
20. Burn hazard
2 SAFETY
15
Burn Hazard
Contact with hot surfaces can
cause burns.
• Do not touch hot
components!
• Allow the machine to
cool thoroughly prior to
servicing.
2030-601
Entanglement Hazard
Rotating parts can cause personal injury.
Keep away from fan and belt while the
engine is running. Stop engine before
servicing.
2030-600
CRUSH HAZARD
Contact with moving machine can
result in death or serious injury.
Keep clear of moving machine.
2030-593
Read Operator’s Manual
Read and understand the operator’s manual
and all safety signs prior to operating or
maintaining the machine.
Improper operation or maintenance can re-
sult in serious injury or death.
No Riders
Fall Hazard
Falling from a machine can result in serious
injury or death.
Carry loads low. Load unload and turn on
level ground. Travel on inclines with heaviest
end of machine uphill.
Rollover/Ejection Hazard
Serious injury or death can result.
2030-598
Fasten Seat Belt
Crush Hazard
Rollover can crush and result in serious injury or death.
Do not use the bucket/attachment as a work platform.
Fall Hazard
Falling can result in serious injury or death.
2030-596
Crush Hazard
Death or serious injury can result
from contact with moving lift arm or
attachment.
Keep clear of lift arms and
attachments.
2030-592
Injection Hazard
Escaping fluid under pressure can
penetrate skin, causing serious injury.
• Relieve internal pressure before
disconnecting any line or fitting.
• Keep away from leaks or pinholes.
• Use cardboard to check for leaks.
Fluid injected into skin must be surgi-
cally removed within a few hours by a
doctor familiar with this type of injury
or gangrene will result.
2030-602
Crush Hazard
Death or serious injury can result
from contact with moving lift arm or
attachment.
Install lift arm brace prior to servicing.
2030-594
Inspect undercarriages daily for
accumulation of debris. If debris
is present, clean thoroughly with
a pressure washer. If debris is
allowed to build up, it can cause
premature component wear and
decrease machine performance.
2085-253
NOTICE
To Next Page
Loading...
