5.12 Operation on Inclines
By design, Compact Track Loaders are very stable on inclines. Machine weight is
distributed evenly throughout the chassis and the suspended undercarriage track
system provides excellent traction and floatation on nearly all surfaces.
5.13 Shut Down Procedure
1. Stop and lower any work attachments that may be coupled to
the machine.
2. Stop the machine in a safe location (on firm and level ground) where it is
protected from the elements and vandals.
3. Lower the lift arms until they rest on the frame stops.
4. Reduce engine RPM to a low idle.
5. Turn the ignition key counterclockwise to stop the engine, remove key.
6. Remove the seat belt and raise the lap bar.
7. Open the door (if equipped) and exit the machine using 3 points of contact
as described in the starting procedure in this section.
5 OPERATION
53
Even with these capabilities, extreme caution should always be exercised
while operating the machine on an incline. Avoid operation on steep
inclines. Do not make sudden changes in direction, move slowly, and always
carry loads low to maximize machine stability.
RT-60/R160T/R190T ROW O&M
0404-659 2016-05
To Next Page
Loading...
Need help?
General
