Terex TR40 - Page 11

Section 000-0000
3SM 1665 1-99
General Information - TR40 Off-Highway Truck
BODY
Longitudinal 'V' type floor with integral transverse box-
section stiffeners. The body rests on resilient impact
absorption pads.
Body wear surfaces are high hardness (360-440 BHN)
abrasion resistant steel. Yield strength of plates 1 000 MPa
(145 000 lbf/in²).
Plate Thicknesses:
Floor ............................................................. 19 mm (0.75 in)
Side .............................................................. 10 mm (0.39 in)
Front, lower .................................................. 10 mm (0.39 in)
ROPS Cabguard SAE J1040 Feb 86. ISO 3471
Volumes:
Struck (SAE) ............................................ 17.2 m³ (22.5 yd³)
Heaped 2:1 (SAE) .................................... 23.9 m³ (31.2 yd³)
SERVICE CAPACITIES
Engine Crankcase & Filters ............... 41 litres (10.8 US gal)
Transmission and Filters....................... 68 litres (18 US gal)
Cooling System................................ 120 litres (31.7 US gal)
Fuel Tank .......................................... 606 litres (160 US gal)
Steering Hydraulic Tank .................... 61 litres (16.0 US gal)
Steering System................................. 85 litres (22.5 US gal)
Body and Brake Cooling Tank ............ 235 litres (62 US gal)
Body and Brake Cooling System ........ 368 litres (97 US gal)
Planetaries (Total) ............................. 66 litres (17.4 US gal)
Differential.......................................... 60 litres (15.8 US gal)
Front Ride Strut (Each) ........................ 14 litres (3.7 US gal)
Rear Ride Strut (Each)......................... 17 litres (4.5 US gal)
Power Takeoff ........................................... 4 litres (1 US gal)
TYPICAL NOISE LEVELS
OPERATOR EAR (ISO 6394) .................................... 80 dbA
* * * *
*EXTERIOR SOUND RATING
(SAE J88 JUN 86)......................................................90 dbA
*The above result is for the mode giving the highest exterior
sound level when measured and operated as per the
prescribed procedures of the standard. Results shown are
for the unit in base configuration.
Note: Noise Level Exposure to the operator and bystander
personnel may be higher depending upon proximity to
buildings, rock piles, machinery etc.. The actual job site
Noise Level Exposure must be measured and applicable
regulations complied with in respect to Employee Hearing
Protection.
VEHICLE WEIGHTS (MASS)
kg lb
Chassis, with hoists 25 350 55 900
Body, standard 9 050 19 950
Net Weight 34 400 75 850
PAYLOAD, maximum 36 300 80 000
Maximum Gross Weight* 70 700 155 850
FOR UNIT EQUIPPED WITH OPTIONAL BODY LINER
PLATES:
Chassis, with hoists 25 350 55 900
Body, with wear plates 10 550 23 260
Net Weight 35 900 79 160
PAYLOAD, maximum 34 800 79 690
Maximum Gross Weight* 70 700 155 850
* Maximum permissible gross vehicle weight with options,
attachments, full fuel tank and payload.
WEIGHT DISTRIBUTION Front Axle Rear Axle
Empty % 48 52
Loaded % 34 66
Find manuals at http://best-manuals.com/search?&s=TEREX-SM1663.PDF