TERMA KTX 2 - Warranty



1. The subject of this warranty is microprocessor-equipped controller for KTX heang
elements, which uses the TERMA-SPLIT system. Product name and characteriscs are
specied on the packaging.
2. By accepng the device on purchase, the Client conrms that the product is of full
value. The Client should immediately inform the Seller of any discovered faults –
otherwise it will be understood that the Product was faultless at the me of pur-
chase. This refers especially to any faults or damages of the control panel case.
3. Warranty period for the Product is 24 months from the date of purchase, but no
longer than 36 months from date of producon.
4. Any claims made will be processed on producon of the warranty card and the
evidence of purchase. Manufacturer has the right to reject any claim on the grounds
of not presenng of any of the above documents.
5. This warranty does not comprise any faults that are due to:
– incorrect (not in accordance with the manual) installaon, use or disassembly,
– incorrect use of the heang element (ie. for any purpose that is not specied by
the Manufacturer as intended for this type of product),
– Product being handled by unauthorized persons,
– any faults or damages caused by the Client aer having purchased and accepted
the Product.
6. Central heang installaon should be ed with lock-shield valves, enabling disas-
sembly of the radiator or the heang element and its control head without the neces-
sity of emptying the whole system of the heang agent. Any problems or expenses
arising from lack of such valves in the installaon cannot not be used as the grounds
for any claims against Terma.
7. The aached Product Manual is an integral element of the Warranty. Please read it
carefully prior to the Product installaon and use.
8. The Manufacturer is obliged to remove any producon fault within 14 working days
from receipt of the faulty device to Manufacturer’s premises.
9. Should the repair turn out impossible, Manufacturer is obliged to replace the faulty
Product with a new, full-value unit of idencal parameters.