EN
Installaon or disassembly
Detailed informaon on all possible ways
of the device installaon or disassembly, is
available from the manufacturer or import-
er of the item (see footer at the boom of
the manual). Below are the most important
requirements and guidelines which should
be strictly followed in order to ensure a long
term, unfailing operaon of device.
Before installaon
1. Read chapter: Guide to safe installaon.
2. If you are installing the ‘ONE electric ra-
diator’ go straight to point 10.
3. The device is intended for operaon in
a vercal posion with heang element
turned upwards.
4. Always use the correct radiator ap-
proved heating mediums only (wa-
ter, water with addion of radiator ap-
proved an-freeze agent only, selected
types of oil).
5. Do not turn the device on if not im-
mersed in water or other liquid as it
could cause damage to thermal fuse
and will not be liable for claim under
warranty.
6. Ensure all necessary safety measures in
order to avoid excessive pressure inside
the radiator (allow the right space for
airbag or leave at least one of the cen-
tral heang valves open).
7. Do not ll the radiator with liquids of
temperature higher than 65° C.
8. Do not install the device in central heat-
ing systems where temperature of liquid
inside the system may exceed 82° C.
9. Make sure that connecon ‘radiator —
heater’ is ght prior to lling the radia-
tor with heang liquid (does not concern
devices preinstalled at the manufactur-
er’s or heater versions built-in inside the
radiator).
10. When connecng the device to installa-
on, follow below instrucons:
a. Brown wire — connecon to live cir-
cuit (L)
b. Blue wire — connecon to neutral
circuit (N)
c. Yellow & green wire — connecon to
earth (PE).
11. For detailed installaon hints — see the
last pages of this manual.
9
To Next Page
Loading...
