MIDI Master USB (English) 7
Windows 2000 installation
The first time you switch the keyboard on, Windows displays a message indicating that the
hardware wizard has detected a newly connected USB audio device. Windows automatically
installs a standard Windows driver for the device. When this is complete, reboot the system.”
· Open the Windows Device Manager (Start / Settings / Control Panel / System / Hardware
/ Device Manager) and double-click the “USB Audio Device” element (labeled with an ex-
clamation point) and check whether the driver is assigned to the MIDIMASTER USB Key-
board (MK-249 USB MIDI Keyboard).
· Select the “Driver” index and then click “Update Driver”. This opens the Hardware Update
Wizard. Click “Next” to begin.
· Select “Display a list of the known drivers for this device... ” and then click “Next”.
· Click “Have Disk” and enter the path for the driver as <CD>:\DRIVER\PC\TERRATECUSBB. If
you like, you can use the “Browse” function to locate the driver.
· On the next screen, select the corresponding “TerraTec MIDI MASTER” element and then
click “Next”.
· The hardware wizard now tells you that it has completed installing the software for this
device. Close the wizard by clicking “Finish”.
· The hardware wizard now informs you that it has found another, unknown hardware com-
ponent. Now select the “Search for a suitable driver for my device...” option and click
“Next”.
· Select “Specify a location”. Here, enter again the path to the CD:
<CD>:\DRIVER\PC\TERRATECUSBB and confirm by clicking “Next”.
· When you see the message “The software you are about to install does not contain a Mi-
crosoft digital signature...”, click the “Continue Setup” option.
· After the second driver has been successfully installed, click “Finish”.
Afterwards, the MIDIMASTER USB Keyboard will be available.
To Next Page
Loading...