15
PLAYING AN AUDIO CD
Load an Audio CD into the player. •
The player will read the disc. Most CDs will start playing
automatically. A track list and the elapsed playing time will
be displayed.
Play Pause:
Press the • /, button at any time to pause playback.
Press the • /, button again to continue to play the
disc.
To change track:
Press the • } or { button to skip to the next or
previous track.
Direct access track selection:
You can jump to a track number by entering the track •
number using the numeric keypad.
Fast search:
Press the • ] or [ button on the remote control
repeatedly to fast search forward or backward
through the CD.
Each time you press the button, the speed will change 2X
g 4X g 8X g20X g Normal
Press • /, to resume play.
To set the volume:
Press the VOL+ or VOL- button to turn the volume •
up or down.
The volume level will be displayed briey.
To stop the disc:
Press the • . button.
Play will stop, holding at the point you stopped the disc.
To resume playing the disc from the point where you •
stopped, press the /, button.
To completely stop the disc:
Press the • . button twice.
The disc will stop.
Repeat play:
Press the REPEAT button repeatedly to step through •
the repeat mode options.
Repeat 1 (repeat the current track)
Repeat all (repeat the disc)
Repeat o
Repeat A-B:
You can mark two points on a CD and play repeatedly
between them.
Play a CD.•
Press the AB button to mark the start of the section •
you want to repeat.
Press the AB button again to mark the end of the •
section.
The player will continually repeat this section.
Press the AB button again to clear AB repeat and •
continue playing normally.
NOTE: You can repeat a section that includes several
tracks.
Audio CD display:
Press the DISPLAY button repeatedly to switch the CD
information display on or o.