FCC and IC Certification
Component Manufacturer Model Operating Frequency (MHz) FCC ID IC ID
Pillar Endpoint
Tesla
1089773
1089773E
13.56
2400-2483.5
2AEIM-10897773
2AEIM-1089773E
20098-1089773
20098-1089773E
Center Console Tesla 1089774
13.56
2400-2483.5
2AEIM-1089774 20098-1089774
Fascia Endpoint
Tesla
1089775
2400-2483.5
2AEIM-1089775 20098-1089775
Key fob Tesla 1133148 2400-2483.5 2AEIM-1133148 20098-1133148
TPMS
Continental TIS-01 433.92 KR5TIS-01 7812-TIS01
Radar Continental ARS 4-B 76000-77000 OAYARS4B 4135A-ARS4B
Homelink Gentex ADHL5C 286-440MHz NZLADHL5C 4112A-ADHL5C
CarPC Tesla
1098058
--
YZP-RBHP-B216C
RI7LE940B6NA
RBHP-B216C
5131A-LE940B6NA
Wireless Charger Tesla
WC2 -- 2AEIM-WC2 20098-WC2
The devices listed above comply with Part 15 of the FCC rules and Industry Canada's license-exempt RSS
Standard(s) and EU Directive 2014/53/EU.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference; and
2.
This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by Tesla could void your authority to operate the equipment.
Radio Frequency Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment
o and
on, try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
Declarations of Conformity
204 MODEL 3 OWNER'S MANUAL
To Next Page
Loading...
