Tesla MODEL X 2021 - Page 139

WARNING: Smart Summon may not
stop for all objects (especially very
low objects such as some curbs, or
very high objects such as a shelf) and
may not react to all oncoming or side
trac. Pay attention and be ready to
stop Model X at all times by releasing
the button on the mobile app.
Standby Mode
To keep Model X ready to Summon and
reduce the time it takes to warm up, turn on
Standby Mode. Touch
Controls > Autopilot >
Standby Mode. When Standby Mode is turned
on, you can conserve Battery energy by
disabling Standby Mode at these locations:
•
Exclude Home - Disables Standby Mode
at the location you set as Home in your
Favorites list.
•
Exclude Work - Disables Standby Mode at
the location you set as Work in your
Favorites list.
•
Exclude Favorites - Disables Standby
Mode at any location in your Favorites list.
NOTE: To conserve energy, Smart Summon
automatically exits Standby mode from
midnight to 6:00 am. During these hours, a
delay occurs as Smart Summon starts up.
NOTE: Additional battery power may be
consumed while Standby Mode is active.
NOTE: For details on how to designate a
location as Home, Work, or Favorites, see
Home, Work, and Favorite Destinations on
page 167.
Stopping or Canceling Smart
Summon
Smart Summon stops Model X whenever you
release the button on the mobile app. To
resume the Smart Summon session, simply
press the
Come to Me or Go to Target button
again.
WARNING:
Always anticipate when
you need to stop Model X. Depending
on the quality of the connectivity
between the phone and Model X,
there may be a slight delay between
when you release the button and
when the car stops.
Smart Summon cancels, and requires you to
restart it, when:
• You press any button on the key fob.
• A door handle is engaged or a door is
opened.
•
You interact with the steering yoke, brake
pedal, accelerator pedal, or shift.
• Model X is blocked by an obstacle.
• Smart Summon has moved Model X the
maximum distance of approximately 475
feet (145 meters) within a 213 foot (65
meter) radius of the phone's location. To
move further than this distance, you must
shift Model X into Drive or Reverse and
then re-initiate an Smart Summon session.
•
Your phone enters sleep mode or loses
connectivity to Model X.
Limitations
Smart Summon is unlikely to operate as
intended in the following types of situations:
•
GPS data is unavailable due to poor
cellular coverage.
•
The driving path is sloped. Smart
Summon is designed to operate on flat
roads only (up to 10% grade).
• A raised concrete edge is detected.
Depending on the height of the concrete
edge, Smart Summon may not move
Model X over it.
• One or more of the ultrasonic sensors or
cameras is damaged, dirty, or obstructed
(such as by mud, ice, or snow, or by a
vehicle bra, excessive paint, or adhesive
products such as wraps, stickers, rubber
coating, etc.).
• Weather conditions (heavy rain, snow,
fog, or extremely hot or cold
temperatures) are interfering with sensor
or camera operation.
• The sensors are aected by other
electrical equipment or devices that
generate ultrasonic waves.
• Model X is in Trailer Mode or an accessory
is attached.
NOTE: Smart Summon is disabled if Model X
is in Valet mode (see Valet Mode on page 56).
Smart Summon
137Autopilot