EMERGENCY RESPONSE GUIDE
10
FIRST RESPONDER CUT LOOP - FRONT TRUNK
The front trunk fi rst responder cut loop consists of low voltage wires. Cutting this loop shuts down the high voltage system and disables
the SRS and airbag components. See cut instructions on page 11.
NOTE: When cutting the loop, double cut to remove an entire section. This eliminates the risk of the cut wires accidentally reconnecting.
The front trunk cut loop is located on the right side,
under the hood and the plastic access panel
FIRST RESPONDER CUT LOOP
DISABLING HIGH VOLTAGE
WARNING: Regardless of the disabling procedure you use, ALWAYS ASSUME THAT ALL HIGH VOLTAGE COMPONENTS ARE ENERGIZED! Cutting, crushing or touching
high voltage components can result in serious injury or death.
NOTE: If the front trunk cut loop is inaccessible in
vehicles built after June 2013, see pages 12-13 for
an alternate disconnect point.
To Next Page
Loading...
