EMERGENCY RESPONSE GUIDE
11
STEP 1: Open the hood (also known as the Front Trunk). See
page 23 for details.
The cut loop is located on the right side. Its label
protrudes from under the plastic access panel.
Cut loop
label
Remove
access
panel
DISABLING HIGH VOLTAGE
STEP 2: Remove the access panel by pulling its rear edge upward
to release the fi ve clips that hold it in place. Maneuver it
toward the windshield to remove.
Double
cut the
loop
STEP 3: DOUBLE CUT the loop to remove an entire section.
Removing an entire section of the cut loop eliminates the
risk of the wires accidentally touching (reconnecting).
WARNING: Regardless of the disabling procedure you use, ALWAYS ASSUME THAT ALL HIGH VOLTAGE COMPONENTS ARE ENERGIZED! Cutting, crushing or touching
high voltage components can result in serious injury or death.
CUTTING THE FIRST RESPONDER LOOP - FRONT TRUNK
To Next Page
Loading...
