EMERGENCY RESPONSE GUIDE
13
STEP 1: Open the rear passenger door closest to the charge port.
The disconnect point is located under the body panel on
the outside of the seat. The label indicates where to cut
into the body panel.
Cut loop
label
DISABLING HIGH VOLTAGE
STEP 2: Use a 12” circular saw to cut 6 in (152 mm) through the
label and into the pillar.
WARNING: Regardless of the disabling procedure you use, ALWAYS ASSUME THAT ALL HIGH VOLTAGE COMPONENTS ARE ENERGIZED! Cutting, crushing or touching
high voltage components can result in serious injury or death.
CUTTING THE FIRST RESPONDER DISCONNECT POINT - REAR PILLAR (NEWER
MODELS ONLY)
To Next Page
Loading...
