28
ENG
Adjusting the rinse aid reservoir
The rinse aid reservoir has six settings. Both the recommended
setting and the factory setting is “4”. If the dishes are not drying
properly or are spotted, adjust the dial to the next higher number
until your dishes are spotless. Reduce it if there are sticky whitish
stains on your dishes or a bluish film on glassware or knife blades.
Filling The Detergent Dispenser
Adjust lever (Rinse)
Push latch to open
Press the release catch on the detergent dispenser to
open the cover.
Close the cover and press on it until it locks into place.
Add detergent into the larger cavity (A) for the main
wash cycle.
For more heavily soiled wash loads, also add some
detergent into the smaller cavity (B) for the pre-wash
cycle.
NOTE
• Be aware that depending on the soiling of water, setting may be different.
• Please observe the manufacturer’s recommendations on the detergent packaging.
To Next Page
Loading...
