PULLER-TENSIONER
Model: AFS404
Manual: MI-AFS404-609-01-GB
4.16 END OF THE OPERATIONS 22
5. INSTRUCTION FOR USE – CONNECTED MACHINES 23
5.1 GENERAL ASPECTS 23
5.2 MACHINES SET-UP 24
5.3 CONNECTED MACHINES OPERATIONS 26
5.4 PULL CONTROL SETTING 26
5.4.1 PULL LIMITING DEVICE SETTING 26
5.4.2 PULL PROGRAMMING DEVICE SETTING 26
5.5 USING OF ELECTRONIC SPEED SYNCHRONIZER DEVICE (OPTIONAL) 27
5.6 ROPE LOCKING CLAMP (OPTIONAL) 27
5.7 ALARM CONDITION WHEN USING CONNECTED MACHINES 27
5.7.1 STRINGING LENGTH ERROR 27
5.7.2 SWITCH ON THE MACHINE WITH CONTROL NOT IN NEUTRAL 27
5.7.3 EMERGENCY STOP 27
5.7.4 CAN-BUS DIS-CONNECTION BETWEEN THE MACHINES 28
5.7.5 ROPE-CLAMP POSITION 28
5.7.6 GEAR-BOX LOW-PULL POSITION 28
5.7.7 CONNECTION MACHINE SELECTOR 28
5.7.8 COMPONENT FAULT 28
6. SAFETY CONDITIONS 29
6.1 SAFETY DEVICES 29
6.2 EMERGENCY STOP DEVICE 29
6.3 PERIODIC OPERATIONS 29
6.4 RESIDUAL RISKS 30
7. MAINTENANCE 31
7.1 GENERAL PRESCRIPTIONS 31
7.2 LEVELS CONTROL 31
7.3 TYRES INFLATION PRESSURE 31
7.4 SUGGESTED LUBRICANTS 31
7.5 ENDOTHERMIC ENGINE MAINTENANCE 31
7.6 HYDRAULIC CIRCUIT MAINTENANCE 32
7.7 REDUCTION GEAR MAINTENANCE 32
7.8 RADIATOR’S MAINTENANCE 33
7.9 GREASING 33
7.10 OTHER PERIODIC OPERATIONS 33
7.11 SUMMARY TABLE FOR ORDINARY MAINTENANCE 33
8. HOW TO DISABLE THE MACHINE 34
8.1 TRANSPORT 34
8.2 EXTENDED SERVICE STOP 34
8.3 STRIPPING 34
9. ENCLOSED DOCUMENTS 35
9.1 TABLES 35
9.2 SYSTEMS 35
9.3 OTHER DOCUMENTS 35
To Next Page
Loading...
