44.. DDiissppllaayy aanndd ccoonnttrrooll eelleemmeennttss
10
4.2 LLED ffunctions
The LED functions can be switched on/off via
testo ComSoft software.
In aall mmodes:
The Alarm led flashes three times every 15 seconds if the remaining
battery capacity is less than10% (even if Alarm led is deactivated).
Wait
mode aand
Key sstart
start ccriterion pprogrammed:
The status led flashes five times if the
GO
button is kept pressed
for approx. 3 s (even if the Status led is deactivated).
It is confirmation that the measuring program was started and that
the data logger is now in the
Record
mode.
Record
mode:
The Alarm led flashes once every 15 s if alarm values have been
exceeded (only if Alarm led is activated).
The Status led flashes once every 15 s (only if the Status led is
activated).
It is confirmation that the measuring program is running.
The Status led flashes five times if the
GO
button is kept pressed
for approx. 3 s (even if Status led is deactivated).
It is confirmation that a time mark has been set.
4.3 DDisplay ssequence
Depending on the mode, different information can be displayed in
the data loggers with display. You will find a detailed description of
the information which can be called up in the short version of the
instruction manual enclosed with every data logger.
Alarm led
(red LED)
Status led
(green LED)
To Next Page
Loading...
Need help?
General
