44.. DDiissppllaayy aanndd ccoonnttrrooll eelleemmeennttss
11
4.4 BButton ffunctions
In aall mmodes iin ddata lloggers wwith ddisplay:
Press the
GO
button to switch between the displays.
Wait
mode aand
Key sstart
start ccriterion pprogrammed:
Press the
GO
button for approx. 3 s to start the measuring
program.
- The measuring program starts,
Record
appears in the display (if
available) and the Status led flashes five times.
Record
mode:
Press the
GO
button for approx. 3 s to set a time mark.
- The Status led flashes five times.
Time mmark:
This function enables you to monitor and read out/print
out the memory content from a specified point in time (
time mark
)
without having to reprogram the data logger. The readings from
Start
(
All readings
) are also saved.
The readings from
Start
(
All readings
) or
From time mark
can be
read out on the testo 575 fast printer or the testo ComSoft software.
The readings from
Start
(
All readings
) can be read out on the
testo 580 data collector.
Only one time mark can be set. If the
GO
button is pressed for
approx. 3 seconds in the
Record
mode, the existing time mark
is deleted and a new time mark is set up.
- The readings (max./min. values, exceeding of alarm values) are
shown in the display (if available) from the set time mark.
To Next Page
Loading...
