3.3 Storage cap
The storage cap filled with electrolyte gel is
used to store the probe between
measurements.
The probe is only immediately ready to
operate if stored in electrolyte gel.
If the probe has been out of the electrolyte gel for a longer period
of time, it must be stored in the electrolyte gel for approx. 12
hours to regenerate.
The storage cap can also be attached to the wall/transport
bracket.
3.4 Wall/Transport bracket
The wall/transport bracket with belt holder
and attachment unit for the storage cap is
used for the safe storage of the
measurement instrument at a fixed point or
during transport.
4. Initial Operation
Insert battery
1
Remove battery compartment.
2
Insert batteries (4x Type LR44).
Watch
out ffor ++/-!!
3
Push battery compartment back in.
4
Remove protection strip on the storage cap.
3. Product Description
7
en
To Next Page
Loading...
Need help?
General
