Need help?Do you have a question about the TESTO 310 and is the answer not in the manual?
General| Measurement Parameters | O2, CO, CO2, Draft, Pressure, Temperature |
|---|---|
| O2 Measurement Range | 0 to 21% |
| CO Measurement Range | 0 to 4000 ppm |
| Product Type | Combustion Analyzer |
| Power Supply | Rechargeable battery |
| Protection Class | IP40 |
| Interfaces | USB |
| Warranty | 2 years |
| Pressure Measurement Range | -40 to +40 hPa |
| Battery Life | 10 hours |
| Display | LCD |
| Storage Conditions | -20 to +50 °C, 10 to 90% RH non-condensing |
| Operating Conditions | 5 to 45 °C, 10 to 90% RH non-condensing |
Guidelines for reading the manual and understanding safety warnings.
Crucial safety precautions for operating and maintaining the instrument.
Proper disposal procedures for batteries and the product.
Details the intended applications and tasks for the testo 310.
Provides detailed technical specifications including measurement ranges and resolution.
Identifies key components visible on the front of the instrument.
Explains the functions of each button on the instrument's keypad.
Describes the instrument's display layout and status icons.
Details the various ports and connection points on the instrument.
Explains the condensate outlet and infrared interface features.
Identifies components located on the rear of the measuring instrument.
Details the components and structure of the flue gas probe.
Explains how regional settings affect parameters and available fuels.
Lists and defines the various parameters shown on the instrument's display.
Information on charging and caring for the instrument's battery.
Step-by-step instructions for charging the instrument's battery.
How to operate the instrument using the mains power supply.
Guide to configuring instrument settings like units, time, and date.
Initial setup and configuration of the instrument's parameters.
Settings related to measurements, including fuel type and units.
Procedures for preparing and performing various measurement types.
Steps to prepare the instrument and probe before taking measurements.
Explanation of the sensor zeroing process required before measurements.
Instructions on checking and aligning the flue gas probe correctly.
How to select the correct fuel type for accurate flue gas analysis.
Steps to select and perform flue gas measurements.
Procedure for measuring ambient carbon monoxide levels.
Instructions for performing draught measurements accurately.
Steps for setting up and performing differential pressure measurements.
Guidelines for cleaning the exterior of the testo 310.
Instructions for cleaning the flue gas probe shaft and handle.
Procedure for safely emptying the condensate trap.
How to check for contamination and replace the particle filter.
Troubleshooting common problems and error messages.
List of available accessories and spare parts with item numbers.
To Next Page
