Need help?Do you have a question about the TESTO 320 and is the answer not in the manual?
General| Power Supply | Rechargeable battery |
|---|---|
| H2-compensated CO sensor | Yes |
| Draft measurement | Yes |
| Differential pressure measurement | Yes |
| Protection Class | IP40 |
| Measurement Parameters | O2, CO, CO2, temperature, draft, differential pressure |
| O2 Measurement Range | 0 to 25% |
| CO Measurement Range | 0 to 4000 ppm |
| CO2 Measurement Range | 0 to 25% |
| Temperature Measurement Range | 0 to 600°C |
| Operating Temperature | 0 to 50°C |
| Resolution | 0.1 °C (temperature), 1 ppm (CO), 0.1% (O2), 0.1% (CO2), 0.01 hPa (differential pressure), 0.01 m/s (flow) |
| Accuracy | ±0.2% (O2), ±5 ppm or ±5% of mv (CO) |
Instructions for safe operation, maintenance, and handling of the instrument.
Detailed technical specifications including certifications and data.
Lists the measuring ranges and resolution for various parameters.
Details the accuracy and response times for different measurement parameters.
Details about the main device, including its front view and keypad.
Initial setup steps, including charging the battery before first use.
Instructions on how to input numerical and text data using list fields or editors.
How to configure various instrument settings for optimal operation.
Procedure for recalibrating and adjusting CO sensors.
How to select and configure fuel types for accurate measurements.
Core procedures for taking measurements with the instrument.
Steps to prepare the instrument and system before taking measurements.
Procedure to test the measurement system for leaks to ensure accuracy.
How to perform gas and draught/pressure zeroing for accurate readings.
Steps for performing a standard flue gas measurement.
Procedure for measuring draught, including probe positioning.
How to perform undiluted CO measurements.
Procedure for measuring pressure, including safety warnings.
How to measure differential temperature using the appropriate set.
How to perform O2 air measurements with the correct probe.
How to measure gas flow rate, noting fuel type availability.
How to measure oil flow, noting fuel type availability.
How to perform ambient CO measurements, noting probe requirements and influences.
How to perform ambient CO2 measurements, noting probe and pressure requirements.
Procedure for gas leak detection, noting probe and country availability.
Step-by-step guide to replace the instrument's rechargeable battery.
Procedure for replacing sensors in the instrument.
Procedure for recalibrating and adjusting CO sensors.
Instructions for downloading and updating the instrument's firmware.
To Next Page
