TESTO 320 - Address;Location

5 First steps
30
5.2.9. Switching off
Unsaved measured values are lost if the flue gas analyser
is switched off.
> Press [ ].
- Depending on the instrument status, the pump starts and the
sensors are rinsed until the switch-off thresholds (O
2
> 20 %,
other measurement parameters < 50 ppm) are reached. Rinsing
lasts no more than 3 minutes.
- The measuring instrument switches off.
5.3. Address/Location
All measuring values can be saved under the currently active
location. Measuring values that have not been saved are lost when
the measuring instrument is switched off!
Addresses and locations can be created, edited, copied and
enabled. Addresses and locations (incl. protocols) can be deleted.
Call up function:
> [ ] → Address/Location → [OK].
There are various options for opening address.
1. Edit search setting: [Edit].
2. Select search setting: [▲], [▼] → [OK].
Possible settings:
• Show all: All address/location are displayed.
• Search: A search text only brings up address/location that
contain characteristics of the search text.
• Filter: Individual letters or numbers can be selected. All data
beginning with the relevant letter/number is displayed.
The initial letter is the determining factor for the filter
function, and this can only be selected individually. The
search
function can also be used to find a series of several
letters within the address!
3. Carry out search according to search setting: [Search]
Show all
1. Select address: [▲], [▼].
2. Show details: [Details].
3. Enable a location: select the location → [OK].
- The location is activated.
> Open measurements menu: press [OK] again.
1.888.610.7664 info@Testo-Direct.com
www.Testo-Direct.com