TESTO 320 - Transferring data

6 Using the product
57
6.3. Transferring data
6.3.1. Report printer
To be able to transmit data via infrared or Bluetooth interface to a
Testo report printer, the printer to be used must have been
activated, see Printer, page 38.
Printing out data takes place via [Print] or [ ]. The function is only
available if a printout is possible.
Representation of the available characters per line is
limited on the printout. Thus, the unit mg/KWh is displayed
on the printout as mg/k.
6.3.2. PC / Pocket PC
Data transfer to a PC can take place via USB, IrDA or Bluetooth
®
.
Data transfer to a Pocket PC can take place via IrDA or Bluetooth
®
.
You must also refer to the documentation that comes with the
software.
1.888.610.7664 info@Testo-Direct.com
www.Testo-Direct.com