Need help?Do you have a question about the TESTO 380 and is the answer not in the manual?
General| NO measurement range | 0 to 3000 ppm |
|---|---|
| Measurement Parameters | O2, CO, NO, Temperature, Draft, Pressure |
| Resolution CO | 1 ppm |
| Resolution NO | 1 ppm |
| Resolution Differential Pressure | 0.01 hPa |
| Resolution Temperature | 0.1 °C |
| Protection Class | IP40 |
| Resolution O2 | 0.1% |
| Accuracy O2 | ±0.2 Vol. % |
| Accuracy Differential Pressure | ±0.03 hPa |
| Storage Temperature | -20 to +50 °C |
General information and usage guidelines for the documentation.
Instructions and warnings for safe operation and handling of the product.
Guidelines for environmentally responsible disposal of product and its components.
Specifies the intended use and compatible instruments for the testo 380.
Detailed technical specifications, including certifications and standards.
Lists all items included in the testo 380 package.
Identifies and labels the components of the testo 380 system.
Details and labels the parts of the particulate matter probe.
Illustrates and identifies the different outlet nozzles on the testo 380.
Shows and lists the cleaning materials provided with the instrument.
Explains the meaning of different status indicators on the testo 380.
Diagram showing the flow path of gases and connections within the system.
Introduction to the product and initial setup steps.
Overview of predefined measurement parameters for particle analysis.
Step-by-step guide for conducting measurements with specific testo 330 model.
Step-by-step guide for conducting measurements with specific testo 330 model.
Procedure for properly ending a measurement session.
Methods for transferring measurement data to other devices or systems.
Recommendation for periodic professional servicing of the measurement system.
Instructions for cleaning the exterior of the testo 380 and testo 330 units.
Steps for safely emptying and draining the condensate container.
Guide for inspecting and replacing fresh air and secondary filters.
Instructions for inspecting and replacing the primary filter.
Guide for inspecting and replacing the cotton filter.
Procedure for cleaning internal components of the rotation diluter.
Instructions for cleaning the probe shaft of the particulate matter probe.
Steps for removing and cleaning or replacing the sensor module.
Procedure for removing and cleaning the measurement nozzle.
Steps for replacing the nozzle with a new or cleaned one.
Instructions for replacing the gas tubes.
Procedure to verify the correct functioning and calibration of the measurement system.
Troubleshooting guide with common error messages and their solutions.
List of available accessories and replacement parts with their item numbers.
Instructions for updating the firmware of the testo 330-2 LL V2010.
Instructions for updating the firmware of the testo 330-2 LL/F.
Instructions for updating the firmware of the testo 380.
To Next Page
