TESTO 380 - Using the product; Particle reading display

6 Using the product
31
6 Using the product
6.1. Particle reading display
The measurement parameters for the Particle measurement type
are predefined and cannot be adjusted.
Overview of measurement parameters:
Display Measurement parameter
g/m
3
PMØ Mean value of the particulate mass since the
start of the measurement
g/m
3
PMØu
Averaged end result dust less measurement
uncertainty (only displayed at the end of
a measurement).
g/m
3
COØu
Averaged end result CO less measurement
uncertainty (the result is only displayed at the
end of a measurement).
% O2
Oxygen concentration
ppm CO
Carbon monoxide concentration
mg/m
3
CO
Carbon monoxide concentration
°C FT
Flue gas temperature
°C AT Combustion air temperature (measurement
only possible and permitted with external
temperature probe 0600 9787).
% FH
Flue gas humidity (calculated)
The mean value display of the following readings can also
be set:
% O2, ppm CO, mg/m
3
CO, °C FT, °C AT, % qA, % FH,
mbar draught