Need help?Do you have a question about the TESTO 300 LL and is the answer not in the manual?
General| NO measurement range | 0 to 3000 ppm |
|---|---|
| NO2 measurement range | 0 to 500 ppm |
| SO2 measurement range | 0 to 5000 ppm |
| Protection class | IP40 |
| Product Type | Combustion gas analyzer |
| CO measurement range | 0 to 4000 ppm |
| Accuracy | Dependent on sensor and range, see datasheet for details |
| Resolution | Dependent on sensor and range, see datasheet for details |
| Power supply | Lithium battery |
Explains warning pictograms and their meaning.
Safety instructions specific to the product.
Initial setup and commissioning of the instrument.
Information on powering the instrument and battery charging.
Step-by-step guide to charging the battery.
Instructions for operating the instrument using AC power.
Procedure for turning the instrument on and off.
Instructions for connecting flue gas and temperature probes.
Overview of the instrument's main user interface elements.
Procedure for checking the gas path for leaks.
Protecting sensors from overload.
Setting alarm thresholds for measurements.
Checking the status of sensors.
Viewing and clearing instrument errors.
Using the setup wizard for initial configuration.
Updating instrument firmware via USB.
Steps to prepare the instrument before measurement.
Explains gas and pressure zeroing procedures.
Procedure for checking the gas path for leaks.
Performing pipe commissioning tightness tests.
Testing gas pipe system serviceability.
Performing a pretest according to EU regulations.
Recommends annual calibration of the instrument.
Displaying the status of the instrument's sensors.
Viewing and clearing instrument errors.
Guide for replacing instrument sensors.
To Next Page
