8 Using the product
31
Wi-Fi
A radio link, such as a Wi-Fi, is not needed for performing
measurements.
Set up a connection to a Wi-Fi router or a Wi-Fi hotspot. The connection allows
sending of measurement reports by e-mail.
Call up function: | Device Settings | Wi-Fi.
Tap Wi-Fi selection field.
Enable Wi-Fi: tap Off button or move grey point to the right.
Instrument switches to On. The point changes to green.
Display of all available Wi-Fi routers or Wi-Fi hotspots in the vicinity.
Select Wi-Fi router or Wi-Fi hotspot.
It may be necessary to enter the password for the selected Wi-Fi.
Connection is set up and shown by Connected.
Further entries via button
Category Description
Add network Enter network name using the keypad,
set security standard and if necessary enter
further options. Save entry.
Display of saved networks.
Refresh
Updating the display of available networks.
Further Wi-Fi settings are displayed.
The Wi-Fi
is disabled in standby mode and enabled again once you quit
standby mode. The enabling process may take a few seconds.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
