6 Using the product
48
6.2.4. External micro pressure probe
The following measurements can be performed using the external
micro pressure probe (0638 0330):
• Ext-Draught
• Ext-Delta-P Single meas.
• Ext-Delta Program
• Ext 4Pa-Measurement (only available if Germany country
version is selected)
• Heating Check (only available if Germany country version is
selected)
See instruction manual for external micro pressure probe.
5.
6.2.5. Average
This function is only available when the Italy country version is
selected.
Call up function:
✓ A flue gas probe or a multi-hole probe (0554 5762) is
connected.
> [ ] → Measurement options → [OK] → Average → [OK].
Options:
> [Options] → Recalibrate: the gas sensors are set to zero.
> [Options] → Addresse/Location: the Address/Location folder
is opened.
> [Options] → Fuels: select fuel.
> [Options] → Sensor detection: once the probe has been
changed, start sensor detection manually.
To calculate the average, a series of 3 measurements are carried
out.
Averaging:
1. Position the flue gas probe in the centre of flow (area of the
highest flue gas temperature).
2. Start measurements
> First measurement: [ ].
> Second and third measurement: [OK]
- The set measurement parameters, measurement period and
measured values are displayed.
- A signal is sounded after 2 min (recommended measurement
period)
1.888.610.7664 info@Testo-Direct.com
www.Testo-Direct.com
To Next Page
Loading...
