6 Maintaining the product
30
6 Maintaining the product
Pos: 52 /TD/Produk t instand halten/tes to 330/testo 330 Instandh altung_Messgerä t reinigen @ 6\mod_1279260 289656_79.doc x @ 66679 @ 22115555 @ 1
6.1. Cleaning the measuring instrument
> If the housing of the measuring instrument is dirty, clean it with
a damp cloth. Do not use any aggressive cleaning agents or
solvents! Mild household cleaning agents and soap suds may
be used.
Pos: 53 /TD/Produk t instand halten/tes to 310/testo 310 Instandh altung Abgassonde r einigen @ 12\mod_13324297 21261_79.docx @ 114502 @ 222255 555 @ 1
6.2. Cleaning the flue gas probe
> In case of contamination, clean the probe shaft and the handle
of the flue gas probe with a damp cloth. Do not use any
aggressive cleaning agents or solvents! Mild household
cleaning agents and soap suds may be used.
Any cleaning of contamination within the probe shaft may
only be carried out by Testo Customer Service.
Pos: 54 /TD/Produk t instand halten/tes to 310/testo 310_Insta ndhaltung Kondensa tbehälter @ 12\mod_13324 29787078_79.doc x @ 114536 @ 1125555 @ 1
6.3. Draining the condensate container
The fill level of the condensate trap can be monitored via the
markings on the condensate trap.
Draining the condensate container
CAUTION
Skin irritation due to condensate!
> Avoid skin contact.
> Make sure that the condensate does not run over the housing.
NOTICE
Damage to the sensors and the flue gas pump due to
condensate entering the gas path!
> Do not empty the condensate container while the flue gas
pump is in operation.
1. Hold the instrument upright, so that the condensate outlet
points upwards.
To Next Page
Loading...
