TESTO 310 - Measurements configuration menu

5 Using the product
23
5.2.2. Measurements configuration menu
This configuration menu enables you to make important settings
relating to a measurement. Fuels and measuring units can be set.
Press right function key ([set]) after the instrument's
initialisation phase.
1. Switch the instrument on: Hold down [], until all segments are
shown on the display.
2. Open Measurements configuration menu: Press right function
key ([set]).
3. Make settings:
Use [esc] to revert to the previous parameter at any
time.
Display /
parameter
Explanation
Fuel Selecting the area version activates different
calculation formulas and measurement
parameters, see Area versions, page 17.
> Select the fuel: [▲] and [▼].
> Switch to the next parameter: [].
> Exit the configuration menu: [OK].
Unit of
pressure
> Select the unit: [▲] and [▼].
> Switch to the next parameter: [OK].
Unit of
temperatur
e
> Select the unit: [▲] and [▼].
> Exit the configuration menu: [OK].
Pos: 45 /TD/Übersc hriften/6.3 Messu ngen durchführen @ 0\mod_118 4584650078_79.doc x @ 1872 @ 3233555455355555555 544555544 @ 1