TESTO 310 - Mains operation; Performing settings; Instrument configuration menu; commissioning

5 Using the product
21
5.1.2. Mains operation
1. Connect the plug of the mains unit to the mains unit socket on
the measuring instrument.
2. Connect the mains plug of the mains unit to a mains socket.
- The measuring instrument is powered by the mains unit.
- If the measuring instrument is switched off, the charging
process starts automatically. Switching the measuring
instrument on has the effect of stopping the battery charging
and the measuring instrument is then powered via the mains
unit.
Pos: 43 /TD/Übersc hriften/6.1 Einste llungen vornehmen @ 0\mod_1 184584321421_79.doc x @ 1863 @ 22235535453535 55354554 @ 1
5.2. Performing settings
Pos: 44 /TD/Produk t verwenden/testo 310/ Testo 310 Konfigurati onsmenü @ 12\mod_133241901 4640_79.docx @ 114200 @ 3323 554455355535555 544555544 @ 1
The instrument has two different configuration menus. The menu
that is opened depends on the instrument status when called up.
5.2.1. Instrument configuration menu / commissioning
When the instrument is switched on initially, the configuration menu
is opened automatically.
Following initial commissioning, the configuration menu can also be
opened again by pressing the right function key [set] during the
instrument's initialisation phase (a duration of approx. 4 seconds).
The values for area version, measuring units, time and date can be
set.
Making settings
1. Switch the instrument on: Hold down [], until all segments
are shown on the display.
2. Open instrument configuration menu: Press right function key
[set] during the initialisation phase.