TESTO 445 - Manual Saving; Automatic Saving

19
5. Memory settings
Manual / Automatic saving
19665
21.85
1:
1:
M.05
MAN
N.0017
m3/h
m/s
19665
1:
1:
M.05 N.0017
m3/h
m/s
AUTO
AUTO
MAN
Manual saving:
Each time is pressed a log of the measurement is saved in
the instrument and includes measured values, location, date and
time. The counter in the top left corner of the display shows the
number of logs saved for this location.
Saving a log with timed or multi-point mean calculation :
The log includes MIN value, MAX value and mean of the
measurement and also single values in multi-point mean
calculations.
AAUUTTOO
OUT
MORY
66
0
AUTO
CYCLE-N.
00
01:3
0
AUTO
CYCLE h
min sec


M.06
N.0001
AAUUTTOO
Cancel saving procedure.
Starts automatic saving again.
An additional measurement series is
added.
EESSCC
LLooccaattiioonn
MEMORY
MAN
MMAANN
AUTO
AUTO
Automatic saving:
When this saving function is set, the instrument automatically
accepts the measured values at fixed intervals and saves them
(=logger operation).
The number of measuring cycles (CYCLE-N.) to be saved and
intervals (CYCLE) have to be programmed:
1. Cycle-N.
The instrument automatically offers the maximum possible number
of measuring cycles. Set required number using
/ / .
Confirm set value by pressing .
2. Cycle
Select interval in which the measured values are to be saved. The
blinking position can be changed using .
Confirm set value by pressing .
Automatic saving is started by pressing . The symbol flashes
until the programmed measurement series is accepted.
ESC
Location