TESTO 557s - Page 20

8 Using the product
20
3
Press [▲] / [▼] to select Evacuation and press [Menu/Enter] to
confirm.
-
The Configure Target Lines menu is
displayed.
4
Adjust the Target Line value
4.1
Press the [▲] key and in the Evacuation Target field, select Manual
Input.
4.2
Press [Menu/Enter] to confirm.
-
The field is activated.
4.3
Press [▲] / [▼] to set the value.
4.4
Press [Menu/Enter] to confirm.
5
Adjust the Maximum Decay Target value.
5.1
Press the [▼] key and in the
Maximum Decay Target field, select
Manual Input.