6. Measuring30
6. Measuring
This chapter describes the steps that are required to
perform measurements with the product.
²
Taking aa mmeasurement:
The instrument is switched on and is in measurement
view.
i Put the probe in position and read off the readings.
With the alarm function on and if the alarm threshold
is exceeded or undershot:
- or flashes and a signal tone is given.
- The alarm goes out if the reading goes below the
upper or above the lower threshold again.
i Switch off signal tone manually: Press .
²
Holding tthe rreading, ddisplaying tthe mmaximum/minimum
value:
The current reading can be recorded. The maximum and
minimum values (since the instrument was last switched
on) can be displayed.
i Press several times until the desired value is
displayed.
- The following are displayed in turn:
· Hold: the recorded reading
· Max: Maximum value
· Min: Minimum value
· The current reading
- In addition to the maximum or minimum readings,
the 2
nd
reading line shows the current reading.
To Next Page
Loading...
