?? ?? nl sv pt it es fr en de
be entered with [].
2 Apply the measured or selected value with [].
3 Press the trigger to calculate the surface temperature via the IR sensor (T
IR
).
- The measured value is displayed.
4 Apply the measured value with [].
- The calculated emission level (
ε) is displayed.
5 Apply the calculated value with [].
8.3 Details: Memory
- The Memory function is opened.
Save - New Location
This function can also be opened directly from the measurement view with [].
A new location can be created.
1 Use []to select Save and open the function with [].
2 Use []to select New Location and open the function with [].
3 Use []and []to enter a memory location description.
4 Use []to select and confirm the entry with [].
Save - Save Measurement Data
This function can also be opened directly from the measurement view with [].
The current measurement data can be saved in an existing memory location. Only the
individual readings currently shown on the display are stored, no series of measure-
ments!
1 Use []to select Save and open the function with [].
2 Select an existing location with []and apply this selection with [].
3 Save the current measurement data with [].
Overview
This function can only be opened via settings mode, not with []from the
measurement view.
Existing memory locations can be displayed and deleted.
Use []to select View and open the function with [].
- The existing locations and the volume of measurement data saved there are
displayed.
To delete a location and the saved measurement data: open the function with [],
confirm with []( ) and carry out deletion with [].
Delete
This function can only be opened via settings mode, not with []from the
measurement view.
The entire memory (measuring locations and measurement data) can be deleted.
1 Use []to select Delete and open the function with [].
2 Confirm with []( ) and carry out deletion with [ ].
198. Settings
To Next Page
Loading...
Need help?
General
