To Next PageTo Next Page
Need help?Do you have a question about the TESTO 845 and is the answer not in the manual?
General| Brand | TESTO |
|---|---|
| Model | 845 |
| Category | Thermometer |
| Language | English |
Explains the meaning of symbols used throughout the manual for clear communication.
Key precautions to prevent harm to users and damage to the instrument during operation.
Guidelines for safe product usage and preserving the warranty claim by adhering to intended use.
Information on the environmentally sound disposal of batteries and the instrument at the end of its life.
Identifies and explains the instrument's components, display, and control buttons for user interaction.
Describes connection options like USB for PC communication and probe sockets for external sensors.
Details the power sources for the instrument, including batteries and mains adapters.
Step-by-step guide for installing batteries or rechargeable batteries into the instrument's compartment.
Instructions on connecting external probes and humidity modules to ensure proper measurement functionality.
Procedure for powering the instrument on and off, including automatic shutdown features.
Guides basic instrument settings like temperature units, display illumination, and laser activation.
Details how to configure measurement parameters like emission degree, alarm limits, and measurement modes.
Explains the concept of emission and provides a table of emission factors for various materials.
Instructions on how to save measurement data and protocols directly on the instrument for later retrieval.
Describes the process for printing stored measurement protocols using the instrument's IR printer.
Explains how to print the currently displayed measurement values from the instrument.
Informs the user about the memory capacity and the 'FULL' display indication when all protocols are stored.
Steps for installing the necessary PC software and USB driver for instrument programming and data management.
Guide on establishing a physical connection between the instrument and a computer using the USB cable.
Instructions for configuring the software to recognize and communicate with the testo 845 for data transfer.
How to establish a data link with the instrument via the software after initial setup.
Overview of the process for programming the instrument's settings, options, and measurement parameters.
Finalizes and applies the programmed settings to the testo 845 instrument after configuration.
Procedure for safely terminating the connection between the instrument and the PC software.
Explains how distance affects the measurement point and introduces measurement optics for accurate readings.
Details the settings and display for performing accurate infrared measurements at close distances.
Describes the setup and display for performing infrared measurements at greater distances.
General guidance on performing measurements, including hold mode and continuous measurement features.
Specific instructions for performing optical infrared temperature measurements with the instrument, including lens care.
How to perform measurements using both infrared and Type K thermocouple probes simultaneously.
Performing measurements with the humidity module, displaying humidity and dewpoint data.
Measuring temperature and humidity using compatible probes, with various display options available.
Measuring and displaying dewpoint distance, including tracking maximum and minimum values.
Measuring surface moisture levels and identifying potential mould risks based on calculated surface moisture.
Instructions for cleaning the exterior of the instrument to maintain its appearance and ensure proper functionality.
Step-by-step guide for safely replacing the batteries in the instrument to ensure continuous operation.
Troubleshooting common problems like the instrument not switching on, laser errors, or battery issues.
Addresses issues related to measurement values, such as out-of-range readings, full memory, or EE errors.
