TESTO 845 - Instrument Programming and Software Use; PC Software and Driver Installation; PC Connection Setup; Software Connection Configuration

157. Programmieren
7. Programming
This chapter describes the handling steps necessary to create measurement
programmes.
7.1 Installing software
In order to adapt the programming of the testo 845 to your individual needs,
you require a PC in which the software testo ComSoft (included in delivery) and
the USB driver have been installed. You will find the instructions for the installa-
tion and operation of the software and the USB driver in the instruction manuals
for testo ComSoft and the USB driver.
i After successfully installing the software, connect
testo 8845 tto tthe PPC
.
7.2 Connecting testo 845 to a PC
i Connect the USB connection cable to your PC.
i Connect the USB connection cable to the testo 845.
i Start the software testo ComSoft.
7.3 Setting up connection
i Start software
testo CComSoft
.
i Select the function Autodetect in the menu bar Instrument .
The window Autodetect opens.
The connection to the testo 845 found is set up automatically and the
name of the connection appears in Archive .
or
i Select the function New device in the menu bar Instrument .
The window New device setup wizard opens.
i Select testo 845 in the instrument choice and click on Next .
i Enter the name of the connection and click on Next .