Basic Operation
Helpline No. UK/Northern Ireland 01270 508538 Rep.Ireland 1800 995 036
Web Support www.quesh.co.uk
Model No: 47743
15
15.CLOCK BUTTON
Press the CLK button briefly to display the time for 5 seconds on the
display, it will then revert back to the previous display until the CLK button
is pressed again.
If you press and hold the CLK button until the real time flashes on the
display, you can adjust the time by using the VOL dial and SEL button.
16.SCAN BUTTON
Press the SCN button to scan for radio frequencies. If a valid signal has
been detected, the frequency will begin to blink for 5 seconds, if you
press the SCN button again it will stop scanning and remain on that
frequency, otherwise the radio will begin to scan for another frequency.
17.Flashing LED
When the front fascia panel is removed the indicator flashes.
18.RESET BUTTON
Before operating the unit for the first time, or after replacing the car
battery, you must reset the unit.
This will erase any stored data on the stereo.
19.RCA Output
The RCA Output Jack is on the back of the unit. (Refer to Wiring) This
output is for connecting amplifier, equalizer, or other audio component
that requires a pre-amp out connection. (Red = Right, White = Left)
Follow the manufacturers instructions for the audio component that you
are connecting.
To Next Page
Loading...
