Need help?Do you have a question about the Tevo LITTLE MONSTER and is the answer not in the manual?
General| Brand | Tevo |
|---|---|
| Model | LITTLE MONSTER |
| Category | 3D Printers |
| Language | English |
Assembly of rubber stands with M6 screws for the base.
Attaching extrusions to the base plate using M5 screws.
Installing sliders and eccentric nuts into extrusions for smooth movement.
Mounting motor brackets and 20T drive pulleys to the frame.
Installing idler pulleys and tensioning the drive belts.
Installing the extruder and securing the belt end to the slider.
Securing the main control board using M3 screws and brass standoffs.
Attaching the power supply box to the printer frame.
Connecting the touch-screen ribbon cable to the main control board.
Details on connecting power supply, motors, and sensors to the main board.
Sequence for powering on, setting up, and calibrating the printer.
Navigating the main menu and accessing sub-menus like Preheat and Move.
Configuring serial connection, port, and baud rate in Repetier Host.
Selecting Slic3r, loading configurations, and preparing G-code.
To Next Page
