To Next Page
О
ОЛЕГDec 8, 2025
Нужно на русском языке Руководство по эксплуатации
Нужно на русском языке Руководство по эксплуатации
Wear safety goggles, disconnect power when not in use, and avoid direct contact with the laser beam.
The manufacturer is not liable for personal injury or property damage resulting from laser operation.
Remove the existing hotend/extruder and attach the laser module to the extruder/hotend plate.
Connect the laser's PWM control wire to the servo port of the MKS GEN board as shown in the diagram.
Connect the 24V to 12V adapter to the PSU and then connect the 12V power connector to the module's DC jack.
Adjust Z-axis, turn on laser at low power, and fine-tune the focus screw for the smallest spot.
Install Inkscape and the Repetier laser plugin to create gcode files for engraving.
Recommended engraving speeds are 100-1500mm/min; testing is encouraged for optimal results.
General| Build Volume | 300 x 300 x 400 mm |
|---|---|
| Print Technology | FDM (Fused Deposition Modeling) |
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD Card |
| Frame Material | Aluminum |
| Heated Bed | Yes |
| Bed Temperature | up to 100 °C |
| Nozzle Temperature | up to 260 °C |
| Extruder Type | Single |
| Frame Structure | Open |
| Power Supply | 24V |
| Layer Resolution | 0.1 - 0.4 mm |
| Print Speed | 20 - 100 mm/s |
| Supported Materials | PLA, ABS, PETG |
| Software | Cura, Repetier-Host |
