Proceed as follows:
1. Apply the supplied double-sided tape to the
device.
2. Fasten the device on the vehicle's battery.
3. Make sure the double-sided tape perfectly
adheres to the battery's surface.
4. Connect the device's red cable to the battery
positive terminal (+12V/+24V).
5. Connect the device's black cable to the
battery negative / ground terminal (-).
Do not remove the device by pulling the power supply cables.
Make sure the +12V / +24V and ground (-) connections are
correct in order to avoid the arising of false alarms from the TMD
MK0 (discharged battery alarm, power disconnection alarm).
20
To Next Page
Loading...
