10.5 Self-diagnosis
The data acquired by the tool is displayed on the display unit through the
software.
The software offers functions that allow you, for example, to:
•
monitor the engineering parameters
•
view and clear the errors detected by the control unit
•
check the logical values in the control unit (ex.: engine running/not running, low
beams on/off)
•
view the information related to the control unit
•
test the operation of the devices controlled by the control unit (actuators)
•
carry out permanent adjustments on certain devices
Furthermore, the software supplies useful technical sheets and guided
procedures to help you carry out particular operations (ex.: resetting the warning
lights).
All the configuration operations of the tool are performed through the software.
For further information regarding the installation of the software and its
use, please refer to the Setup Manual and Operating Manual.
32
To Next Page
Loading...
