Timer_A Operation
11-15
Timer_A
Output Example—Timer in Continuous Mode
The OUTx signal is changed when the timer reaches the TACCRx and
TACCR0 values, depending on the output mode. An example is shown in
Figure 11−13 using TACCR0 and TACCR1.
Figure 11−13.Output Example—Timer in Continuous Mode
0h
0FFFFh
TAIFG
Output Mode 1: Set
Output Mode 2: Toggle/Reset
Output Mode 3: Set/Reset
Output Mode 4: Toggle
Output Mode 5: Reset
Output Mode 6: Toggle/Set
Output Mode 7: Reset/Set
TACCR0
TACCR1
EQU1 TAIFG EQU1 EQU0 Interrupt EventsEQU0
To Next Page
Loading...
